Iot Exit Off Jam / Iot Exit Off Early Jam - Xerox Phaser 6500 Service Manual

IOT Exit Off JAM / IOT Exit Off early JAM

Phaser 6500/WorkCentre 6505 Service Manual
Troubleshooting Procedure (continued)
Step Actions and Questions
27 Check the voltage across J23-5 <=>
ground on the MCU Board.
Remove the Lower Chute Assembly
(page 8-84; PL3.2.27) to check the
operation of the Registration Sensor.
Does the voltage change when you
operate the Registration Input
Actuator?
Applicable Error Codes
• 077-104 / 077-105
Troubleshooting Reference Table
Applicable Parts
Fuser Assy (PL6.1.1)
■
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Fuser Harness Assy (PL6.1.2)
■
Feeder Assy. (PL 3.1.98)
■
Drive Clutch Assy. (PL 3.1.97)
■
Warning
To avoid possible burns, allow the Fuser Assy to cool before beginning the
procedure.
Troubleshooting Procedure
Step Actions and Questions
1 Check the error.
Replace to known good paper.
Does the error still occur when
printing?
2 Perform the procedure "Exit Sensor" on
page 4-23 to check the Exit Sensor
operation.
Does the number on the screen
increase by one, when you operate the
Exit Sensor actuator in the Fuser Assy?
Xerox Internal Use Only
Error Messages and Codes
Yes
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
Wiring and Plug/Jack Map References
"Map 1 - SFP Print Engine" on
■
page 10-6
"Map 6 - MFP Print Engine" on
■
page 10-15
"SFP Fuser" on page 10-33
■
"MFP Fuser" on page 10-46
■
Yes
Go to step 2.
Go to step 7.
No
Replace the
Registration
Sensor
(page 8-80)
No
Complete.
Go to step 3.
3-125