Iot Sub Motor Failure - Xerox Phaser 6500 Service Manual

IOT Sub Motor Failure

Phaser 6500/WorkCentre 6505 Service Manual
Applicable Error Code
• 042-326
Troubleshooting Reference Table
Applicable Parts
Sub Drive Assembly (PL7.1.1)
■
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Sub Motor Harness Assy (PL9.1.8)
■
Warning
To avoid possible burns, allow the Fuser Assy to cool before beginning the
procedure.
Troubleshooting Procedure
Step Actions and Questions
1 Does the error still occur when the
power is turned Off and On?
2 Reseat the Fuser Assy and Imaging
Unit.
Does the error still occur when the
power is turned Off and On?
3 In the Printer Diagnostic tests, use
Engine Diag > Motor Test > Sub
Motor FULL1.
Does the Sub Motor function
normally?
4 Check the connections between the
MCU Board and Sub Drive Assembly.
Are P/J22 and P/J221 connected
correctly?
5 Does the error still occur when the
power is turned Off and On?
Xerox Internal Use Only
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 3 - SFP IP Board, LVPS, and Drive"
■
on page 10-8
"Map 4 - SFP MCU Board" on
■
page 10-9
"SFP Main Drive" on page 10-28
■
"Map 8 - MFP LVPS, IP Board, and
■
Drive" on page 10-17
"Map 9 - MFP MCU Board and HVPS"
■
on page 10-18
"MFP Main Drive" on page 10-41
■
Yes
Go to step 2.
Go to step 3.
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
Go to step 6.
Go to step 6.
No
Complete.
Complete.
Go to step 4.
Reconnect the
connector(s) P/
J22 and/or P/
J221 correctly,
then go to step
5.
Complete.
3-87