Abnormal Noise During Standby - Xerox Phaser 6500 Service Manual

General Troubleshooting

Abnormal Noise During Standby

4-74
Troubleshooting Procedure Table (continued)
Step Actions and Questions
4 Check for proper Main Drive Assembly
installation.
Test the Main Drive (page 4-29):
Service Mode > Engine Diag > Motor
Test > Main Motor FULL2.
Is the noise still present?
5 Test the Sub Drive (page 4-30): Service
Mode > Engine Diag > Motor Test >
Sub Motor FULL2.
Is the noise still present?
6 Reseat the Imaging Unit.
Test the Sub Drive test (page 4-30):
Service Mode > Engine Diag > Motor
Test > Sub Motor FULL2.
Is the noise still present?
7 Reseat the Fuser.
Test the Sub Drive (page 4-30): Service
Mode > Engine Diag > Motor Test >
Sub Motor FULL2.
Is the noise still present?
8 Reseat the Sub Drive Assembly.
Test the Sub Drive (page 4-30): Service
Mode > Engine Diag > Motor Test >
Sub Motor FULL2.
Is the noise still present?
Troubleshooting Reference Table
Applicable Parts
Fan, PL8.1.1
LVPS, PL8.2.1
Xerox Internal Use Only
http://www.manuals4you.com
Yes
Replace in
order:
Imaging Unit
(page 8-7)
Transfer Belt
(page 8-112)
.
Main Drive
Assembly
(page 8-114)
.
Go to step 6.
Go to step 7.
Go to step 8.
Replace in
order:
Imaging Unit
(page 8-7)
Fuser
(page 8-10)
Sub Drive
Assembly
(page 8-113)
.
Wiring and Plug/Jack Map References
Phaser 6500/WorkCentre 6505 Service Manual
No
Complete
Check
operating
environment
and electrical
grounding.
Complete
Complete
Complete