Xerox Phaser 6500 Service Manual page 648

Service Parts Disassembly
8-200
20. Remove two screws (silver, 6mm) that secure the IIT Sub-Assembly to the
chassis. Shift the IIT Sub-Assembly to left to release the holes of the assembly
from the four studs to remove the IIT from the chassis.
Replacement Note
When replacing the IIT Sub-Assembly on the chassis, take care not to pinch
the harnesses, particularly the ADF Assembly harness.
When replacing the IIT Sub-Assembly with new part, be sure to perform the
procedure "Scanner Parameter Setting" on page 6-11.
Xerox Internal Use Only
http://www.manuals4you.com
Phaser 6500/WorkCentre 6505 Service Manual
s6500-385