Iot Side Cover Open - Xerox Phaser 6500 Service Manual

Error Messages and Codes

IOT Side Cover Open

Applicable Error Code
3-132
Troubleshooting Procedure (continued)
Step Actions and Questions
6 Check the LVPS Main Harness Assy for
continuity.
Disconnect J14 from the MCU Board.
Disconnect J501 from the LVPS.
Is each cable of J14 <=> J501
continuous?
7 Check the power to the Interlock
Switch
Disconnect the connector of J44 on
the LVPS.
Is the voltage across P44-1 <=> ground
on the LVPS, about +24 VDC?
8 Check the Interlock Switch for
operation
Check the voltage across P44-3 <=>
ground on the LVPS.
Does the voltage change, when the
Interlock Switch is turned On/Off?
• 077-301
Troubleshooting Reference Table
Applicable Parts
Toner Door (SFP PL1.1.7;MFP
■
PL1.1.7)
Toner Door Switch (PL5.1.9)
■
Toner Dispenser Assembly
■
(PL5.1.1)
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Xerox Internal Use Only
http://www.manuals4you.com
Yes
Go to step 7.
Go to step 8.
Replace the
LVPS (SFP,
page 8-124;
MFP,
page 8-145)
Wiring and Plug/Jack Map References
"Map 1 - SFP Print Engine" on
■
page 10-6
"Map 3 - SFP IP Board, LVPS, and Drive"
■
on page 10-8
"Map 6 - MFP Print Engine" on
■
page 10-15
"Map 8 - MFP LVPS, IP Board, and
■
Drive" on page 10-17
"SFP LVPS" on page 10-26
■
"MFP LVPS" on page 10-39
■
Phaser 6500/WorkCentre 6505 Service Manual
No
Replace the
LVPS Main
Harness Assy.
Replace the
LVPS (SFP,
page 8-124;
MFP,
page 8-145)
Replace the
Interlock
Harness Assy.
(SFP,
page 8-125;
MFP,
page 8-146)