Printer Is Making Unusual Noises; Paper Tray Will Not Close; Condensation Has Formed Inside The Printer - Xerox VersaLink C405dn User Manual

Troubleshooting
P P r r i i n n t t e e r r i i s s M M a a k k i i n n g g U U n n u u s s u u a a l l N N o o i i s s e e s s
Probable Causes
There is an obstruction or debris inside the printer.
P P a a p p e e r r T T r r a a y y W W i i l l l l N N o o t t C C l l o o s s e e
Probable Causes
The paper tray does not fully close.
C C o o n n d d e e n n s s a a t t i i o o n n h h a a s s F F o o r r m m e e d d I I n n s s i i d d e e t t h h e e P P r r i i n n t t e e r r
Moisture can condense inside a printer where the humidity is above 85% or when a cold printer is
located in a warm room. Condensation can form in a printer after it has been sitting in a cold room
that is heated quickly.
Probable Causes
The printer has been sitting in a cold room.
The relative humidity of the room is too high.
200 Xerox ® VersaLink
User Guide
® C405 Color Multifunction Printer
Solutions
Power off the printer, then remove the
obstruction or debris. If you cannot remove the
obstruction, contact your Xerox representative.
Solutions
• If the tray is extended for legal-size paper, the
tray protrudes when it is inserted into the printer.
For more information, refer to
or 2 for the Paper Length.
• Some debris or an object is blocking the tray.
• The tray is blocked by the table or shelf on which
it is located.
• If the paper lift plate at the back of the tray is not
locked down, replace the tray.
Solutions
Allow the printer to operate for several hours at room
temperature.
• Reduce the humidity in the room.
• Move the printer to a location where the
temperature and relative humidity are within the
operating specifications.
Configuring Trays 1