Error Messages and Codes
PHD Tape Staying
Applicable Error Code
3-140
•
091-912
Troubleshooting Reference Table
Applicable Parts
Imaging Unit (PL4.1.21)
■
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Troubleshooting Procedure
Step Actions and Questions
1
Turn off the power, and open the Front
Cover.
Remove the Imaging Unit.
Have all eight sealing tapes been
removed?
After Check, reseat the Imaging Unit
correctly.
2
Does the error still occur when the
power is turned Off and On?
3
Replace the Imaging Unit. (page 8-7)
Caution:
Be sure to pull all eight
sealing tapes out from a new
Imaging Unit before
installation.
Does the error still occur when the
power is turned Off and On?
Xerox Internal Use Only
http://www.manuals4you.com
Wiring and Plug/Jack Map References
—
Yes
Go to step 3.
Go to step 3.
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
Phaser 6500/WorkCentre 6505 Service Manual
No
Pull out the
sealing tapes,
then go to step
2.
Complete.
Complete.