Option Feeder Motor Failure - Xerox Phaser 6500 Service Manual

Option Feeder Motor Failure

Phaser 6500/WorkCentre 6505 Service Manual
Troubleshooting Procedure (continued)
Step Actions and Questions
6 Check the Option Harness Assy for
continuity.
Disconnect P/J27 from the MCU
Board.
Disconnect P/J273 from the Tray
Harness Assy.
Is each cable of P/J27 <=> P/J273
continuous?
7 Check after replacing the Optional
Feeder.
Replace the Replace the Optional
Feeder. (page 8-167)
Does the error still occur when the
power is turned Off and On?
Applicable Error Code
• 072-216
Troubleshooting Reference Table
Applicable Parts
Motor Subassembly (PL12.2.98)
■
Feeder Board (PL12.2.1)
■
Tray Motor Harness Assy
■
(PL12.2.2)
Optional Feeder (PL12.1.99)
■
Troubleshooting Procedure
Step Actions and Questions
1 Does the error still occur when the
power is turned Off and On?
2 Check the connectors of the Motor
Subassembly for connection.
Check the connections between the
Feeder Board and Motor Subassembly.
Are P/J422 and P/J4221 connected
correctly?
3 Does the error still occur when the
power is turned Off and On?
Xerox Internal Use Only
Error Messages and Codes
Yes
Go to step 7.
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
Wiring and Plug/Jack Map References
"Map 5 - SFP Optional Feeder" on
■
page 10-10
"SFP Option Feeder" on page 10-35
■
"Map 10 - MFP Optional Feeder" on
■
page 10-19
"MFP Option Feeder" on page 10-50
■
Yes
Go to step 2.
Go to step 4.
Go to step 4.
No
Replace the
Option
Harness Assy.
Complete.
No
Complete.
Reconnect the
connector(s) P/
J422 and/or P/
J4221
correctly, then
go to step 3.
Complete.
3-111