Mfp Interlock Harness - Xerox Phaser 6500 Service Manual

Service Parts Disassembly

MFP Interlock Harness

MFP PL8.1.1 (Harness Assy Interlock AIO [SW-J44])
8-146
1. Perform the service preparation steps on page 8-3.
2. Open the Front Cover.
3. Remove the Left Side Cover (page 8-37).
4. Remove the Outer Pole Cover (page 8-39).
5. Remove the Rear Cover (page 8-43).
6. Remove the Right Side Cover (page 8-40).
7. Remove the Top Cover (page 8-45).
8. Disconnect P/J44 on the LVPS, and release the harness from the two clamps.
9. Remove the 3 clamps on the Top Plate Assembly that secure the harness, then
pull the harness through the hole.
Xerox Internal Use Only
http://www.manuals4you.com
Clamps
Phaser 6500/WorkCentre 6505 Service Manual
P/J44
s6500-336
s6500-337