Xerox Phaser 6500 Service Manual page 170

Error Messages and Codes
3-42
Troubleshooting Procedure (continued)
Step Actions and Questions
5 Check the Fuser Harness Assy for
continuity.
Disconnect J17 from the MCU Board.
Disconnect J47 from the LVPS.
Is each cable of J17 and J47 <=> P171
continuous?
NOTE P171 is attached to the frame.
6 Check the LVPS Main Harness Assy for
continuity.
Disconnect J14 from the MCU Board.
Disconnect J501 from the LVPS.
Is each cable of J14 <=> J501
continuous?
7 Replace the Fuser Assy. (page 8-10)
Does the error still occur when the
power is turned Off and On?
NOTE After replacing the Fuser, be
sure to reset the Fuser counter.
8 Check after the LVPS.
Replace the LVPS. (SFP, page 8-124;
MFP, page 8-145)
Does the error still occur when the
power is turned Off and On?
Xerox Internal Use Only
http://www.manuals4you.com
Yes
Go to step 6.
Go to step 7.
Go to step 8.
Replace the
MCU Board
(SFP,
page 8-138;
MFP,
page 8-160)
Phaser 6500/WorkCentre 6505 Service Manual
No
Replace the
Fuser Harness
Assy.
Replace the
LVPS Main
Harness Assy.
Complete.
Complete.