Xerox Phaser 6500 Service Manual page 137

Phaser 6500/WorkCentre 6505 Service Manual
Error Code List & Error Message Summary (continued)
Error Message
Error Code
LCD
016 767 Invalid Email Address
Error 016-767
Press Ok Button
768 Invalid 'From' Address
Error 016-768
Press Ok Button
770 Network Error
Invalid MPC FW
Error 016-770
Press Ok Button
786 Network Scan Error
Communication Timeout
Error 016-786
Press Ok Button
790 Network Not Ready
Error 016-790
Press Ok Button
791 USB Memory Error
USB Memory was removed.
Error 016-791
Press Ok Button
799 Invalid Job
Error 016-799
Press Ok Button
930 USB Host Error
Unsupported Device
Error 016-930
Remove from USB Port
931 USB Host Error
Hub is not supported
Error 016-931
Remove from USB Port
This code is given when the optional 512 MB memory module is installed.
982 RAM Disk Full
Job too Large
Error 016-982
Press Ok Button
Xerox Internal Use Only
Error Messages and Codes
Error Description
<Invalid Recipient Email Address>
Recipient email address is incorrect.
Check the Address Book Email Address.
<Invalid Sender Address (Login Error)>
Sender email address syntax is incorrect.
In CWIS go to Properties > Protocols >
Email Settings. Verify that the Return
Email Address, if entered, follows the
correct syntax, e.g. "user @ xerox.com."
The address need not be valid, but must
use correct syntax.
<MPC Firmware Version Mismatch>
Error occurred when connecting to server
during file transfer.
Check the network settings and Scan to
Net settings.
<Data Send/Receive Timeout Error>
Timeout error occurs in scan data send/
receive.
<F2N Module Starting-up>
F2N module task is starting up, or IP
address is not determined.
Check the IP address.
<USB Memory Removal Error (During
Read)>
USB memory is removed while memory
reading job is being executed.
<Job Environment Violation>
Detects violation data for the print
condition. The print data specifies paper
type/ size not available for the printer.
<USB HOST Error>
Devices not supported have been
detected.
<USB HOST Error>
It has been found that more stages of
hubs than supported are connected.
<Disk Full>
The current printing job process cannot
be continued because the RAM disk is
full.
Go To
—
—
—
page
45
—
page
53
page
53
page
54
page
54
page
55
3-9