Xerox Phaser 6500 Service Manual page 230

Error Messages and Codes
3-102
Troubleshooting Procedure (continued)
Step Actions and Questions
13 Check the paper lead edge staying
position.
Does the paper lead edge stay before
the Regi Roller Assy and Regi Metal
Roller?
14 Check the paper path.
Remove the Tray 1 and Tray 2 paper
cassettes.
Are there any obstacles on the paper
transfer path between the Tray 2 and
the Regi Assy?
15 Check the connections between the
Feeder Board and Paper Path Sensor.
Are P/J420 and P/J4202 connected
correctly?
16 Check the Tray Comp Harness Assy for
continuity.
Disconnect J420 from the Feeder
Board.
Disconnect J4202 from the Paper Path
Sensor.
Is each cable of J420 <=> J4202
continuous?
17 Check the power to the Paper Path
Sensor.
Disconnect J420 from the Feeder
Board.
Is the voltage across P420-6 <=>
ground on the Feeder Board, about
+3.3 VDC?
18 Check the Paper Path Sensor for
operation.
Check the voltage across J420-5 <=>
ground on the Feeder Board.
Does the voltage change, when you
operate the Registration Input
Actuator?
19 Check the connections between the
Feeder Board and Motor Subassembly.
Are P/J422 and P/J4221 connected
correctly?
Xerox Internal Use Only
http://www.manuals4you.com
Yes
Go to step 14.
Remove the
obstacles or
stains from the
paper transfer
path.
Go to step 16.
Go to step 17.
Go to step 18.
Replace the
Feeder Board.
(page 8-173)
Go to step 20.
Phaser 6500/WorkCentre 6505 Service Manual
No
Replace the
Optional
Feeder.
(page 8-167)
Replace the
Optional
Feeder.
(page 8-167)
Reconnect the
connector(s)
P/J420 and/or
P/J4202
correctly.
Replace the
Tray Comp
Harness Assy.
(PL 12.2.20)
Replace the
Feeder Board.
(page 8-173)
Replace the
Paper Path
Sensor.
(page 8-187)
Reconnect
P/J422 and/or
P/J4221
correctly.