IOT Duplexer Failure
Phaser 6500/WorkCentre 6505 Service Manual
Troubleshooting Procedure (continued)
Step Actions and Questions
12
Disconnect J23 from the MCU Board
and measure the voltage across P23-3
<=> ground on the MCU Board.
Is the voltage about +3.3 VDC?
13
Check the voltage across P23-5 <=>
ground on the MCU Board.
Remove the Lower Chute Assembly
(page 8-84; PL3.2.27) to check the
operation of the Registration Sensor.
Does the voltage change when you
operate the Registration Input
Actuator?
14
Check after replacing Duplex Unit.
Replace Duplex Unit. (page 8-162)
Does the error still occur when
printing?
15
Check after replacing Fuser Assy.
Replace Fuser Assy.
Does the error still occur when
printing?
NOTE: After replacement, be sure to
clear life counter value.
Applicable Error Code
•
077-215
Troubleshooting Reference Table
Applicable Parts
Option Harness Assy (PL3.1.20)
■
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Duplex Harness Assy (PL11.1.14)
■
Duplex Unit (PL11.1.1)
■
Xerox Internal Use Only
Error Messages and Codes
Yes
Go to step 13.
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
Go to step 15.
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
Wiring and Plug/Jack Map References
"Map 1 - SFP Print Engine" on
■
page 10-6
"Map 6 - MFP Print Engine" on
■
page 10-15
"Map 11 - Duplex Unit" on page 10-20
■
"SFP Duplex Unit" on page 10-36
■
"MFP Duplex Unit" on page 10-51
■
No
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
Replace the
Registration
Sensor.
Complete.
Complete.
3-129