Printer Makes Unusual Noises; Condensation Has Formed Inside The Printer; Paper Curl - Xerox B205 User Manual

Printer Makes Unusual Noises

Probable Causes
There is an obstruction or debris inside
the printer.

Condensation has Formed Inside the Printer

Moisture can condense inside a printer when the humidity is above 85% or when a cold printer is in a
warm room. Condensation can form in a printer after it has been sitting in a cold room that is heated
quickly.
Probable Causes
The printer has been sitting in a cold
room.
The relative humidity of the room is too
high.

Paper Curl

If your printed output has more than 20
rear exit.
1. Open the rear cover.
2. Leave the rear cover open. Prints will be delivered face up.
Note: The rear cover output can only be used for jobs one
sheet at a time.
Solutions
1. Power off the printer.
2. Remove the obstruction or debris.
Note: If you cannot remove the obstruction or debris, contact a
service representative
Solutions
• Before operating the printer, allow it to acclimate for several
hours.
• Allow the printer to operate for several hours at room
temperature.
• Reduce the humidity in the room.
• Move the printer to a location where the temperature and
relative humidity are within the operating specifications. For
details, refer to Environmental
curl, or wrinkling occurs when printing envelopes, use the
mm
General Troubleshooting
Specifications.
Xerox B205 Multifunction Printer
®
User Guide
194