Feed Roller - Xerox Phaser 6500 Service Manual

Feed Roller

PL3.2.4 (Roll Assy Feed)
Phaser 6500/WorkCentre 6505 Service Manual
1. Remove Tray 1.
2. Open the Front Cover.
3. Lower the Transfer Belt.
4. Remove the Imaging Unit (page 8-7)
5. Reach in through the opening in the bottom of the Imaging Unit cavity and
release the hook on the left side of the roller. Move the roller core to the left
side.
6. Move the Feed Roller to the left, so that the grooves in the Feed Roller are clear
of the pins on the feed shaft.
7. Rotate the Feed Roller 180
drop off the shaft.
Replacement Note
Because there are grooves in only one side of the Feed Roller, it fits over the
pins on the feed shaft in only one direction. Note the location of the grooves
when installing the Feed Roller on the shaft.
Xerox Internal Use Only
o
on the feed shaft and allow the Feed Roller to
Service Parts Disassembly
s6500-178
8-9