Vertical Stripes - Xerox Phaser 6500 Service Manual

Vertical Stripes

Phaser 6500/WorkCentre 6505 Service Manual
There are Black lines along the page in the direction of the paper travel from the
leading edge to the trailing edge.
Initial Actions
• Check the media path.
• Ensure there are no debris on the transfer path.
Troubleshooting Reference Table
Applicable Parts
Imaging Unit, PL4.1.21
Laser Unit, PL4.1.99
Fuser, PL6.1.1
Transfer Belt, PL6.1.7
IP Board, PL8.1.7
MCU Board, PL8.2.13
Allow the Fuser to cool before starting the procedure.
Troubleshooting Procedure
Step Actions and Questions
1 Print an Engine Test print
(page 4-47).
Is the test print printed correctly?
2
Check the Transfer Belt high-voltage
connections.
Are the contacts on the Transfer Belt
and springs damaged or dirty?
3 Check the Imaging Unit high-
voltage connections.
Are the contacts on the Imaging
Unit, and springs damaged or dirty?
4 Reseat the Imaging Unit.
Does the error persist?
Xerox Internal Use Only
Print-Quality Troubleshooting
Example Print
Yes No
Replace the IP Go to step 2.
Board
(page 8-120).
Clean or Go to step 3.
replace the
Transfer Belt
contacts or
spring(s).
Clean and/or Go to step 4.
replace the
Imaging Unit
or spring(s).
Complete Go to step 5.
Vertical Stripes
5-19