Iot Feeder Configuration Failure - Xerox Phaser 6500 Service Manual

Error Messages and Codes

IOT Feeder Configuration Failure

Applicable Error Code
3-110
• 072-215
Troubleshooting Reference Table
Applicable Parts
Option Harness Assy
■
(PL3.1.20)
MCU Board (SFP PL8.2.13;
■
MFP PL8.3.6)
Optional Feeder (PL12.1.99)
■
Tray Harness Assy (PL12.3.23)
■
Troubleshooting Procedure
Step Actions and Questions
1 Check the Optional Feeder for
installation.
Is the Optional Feeder installed
correctly?
2 Does the error still occur when the
power is turned Off and On?
3 Check the connectors for connection.
Check the connections between the
Feeder Board and MCU Board.
Are P/J27, P/J273, and P/J419
connected surely?
4 Does the error still occur when the
power is turned Off and On?
5 Check the Tray Harness Assy for
continuity.
Disconnect P/J419 from the Feeder
Board.
Disconnect P/J273 from the Option
Harness Assy.
Is each cable of P/J419 <=> P/J273
continuous?
Xerox Internal Use Only
http://www.manuals4you.com
Wiring and Plug/Jack Map References
"Map 2 - SFP Laser Unit and Feeder" on
■
page 10-7
"Map 4 - SFP MCU Board" on page 10-9
■
"Map 5 - SFP Optional Feeder" on
■
page 10-10
"Map 6 - MFP Print Engine" on page 10-15
■
"Map 9 - MFP MCU Board and HVPS" on
■
page 10-18
"Map 10 - MFP Optional Feeder" on
■
page 10-19
"SFP Option Feeder" on page 10-35
■
"MFP Option Feeder" on page 10-50
■
Yes
Go to step 3.
Go to step 3.
Go to step 5.
Go to step 5.
Go to step 6.
Phaser 6500/WorkCentre 6505 Service Manual
No
Reseat the
Optional
Feeder, then
go to step 2.
Complete.
Reconnect the
connector(s) P/
J27, P/J273
and/or P/J419
surely, then go
to step 4.
Complete.
Replace the
Tray Harness
Assy.