YASKAWA FSDrive-MV1000 Parameter Manual page 236

2.10 o: Operator Related Settings
Setting 0: Copy Select (no function)
Setting 1: INV --> OP READ
All parameters are copied from the drive to the digital operator.
Setting 2: OP --> INV WRITE
All parameters are copied from the digital operator to the drive.
Setting 3: OP<-->INV VERIFY
Parameters in the drive are compared with the parameter settings saved on the digital operator to see if they match.
o3-02: Copy Allowed Selection
n
Restricts or allows the use of the Copy function.
No.
o3-02 Copy Allowed Selection
Setting 0: Disabled
Setting 1: Enabled
u o4: Maintenance Monitor Settings
o4-01: Cumulative Operation Time Setting
n
Sets the cumulative operation time of the drive. The user can also manually set this parameter to begin keeping track of
operation time from some desired value. Total operation time can be viewed in monitor U4-01.
Note: The value in o4-01 is set in 10 h units. For example, a setting of 30 will set the cumulative operation time counter to 300 h. 300 h
will also be displayed in monitor U4-01.
No.
o4-01 Cumulative Operation Time Setting
o4-02: Cumulative Operation Time Selection
n
Selects the conditions for how the drive keeps track of its total operation time. This time log can be viewed in U4-01.
No.
o4-02 Cumulative Operation Time Selection
Setting 0: Power on time
The drive logs the time it is connected to a power supply, regardless of whether the motor is running.
Setting 1: Run time
The drive logs the time that the output is active. This includes whenever the Run command is active (even if the motor is
not rotating) and when there is voltage output.
o4-11: U2, U3 Initialization
n
Resets the fault trace and fault history monitors (U2-
these monitors.
No.
o4-11
Setting 0: No action
The drive keeps the record already saved concerning fault trace and fault history.
Setting 1: Reset fault data
Resets the data for the U2-
ENTER key is pressed, fault data is erased and the setting of the parameter returns to 0.
236
Name
Name
Name
Name
U2, U3 Initialization
(Fault Trace) and U3-
Setting Range
0, 1
Setting Range
0 to 9999
Setting Range
0, 1
and U3- ). Initializing the drive using A1-03 does not reset
Setting Range
0, 1
(Fault History) monitors. When o4-11 is set to 1 and the
YASKAWA ELECTRIC TOEP C710687 03B FSDrive-MV1000 Parameter Guide
Default
0
Default
0
Default
0
Default
0