YASKAWA FSDrive-MV1000 Parameter Manual page 167

F4-03: Analog Output 5 (Terminal V1) Bias
n
Parameter F4-03 determines the bias. This parameter is set as a percentage of the output signal from analog output 5
(terminal V1) where 100% equals 10 V output. The terminal output voltage is limited to 10 V.
No.
F4-03
F4-04: Analog Output 5 (Terminal V1) Cell Selection
n
Parameter F4-04 determines the power cell number to be output from analog output 5 (terminal V1). This parameter is
effective when 9oo (power cell) has been set for F4-01 (Analog Output 5 (Terminal V1) Monitor Selection).
No.
F4-04
F4-05: Analog Output 5 (Terminal V1) Signal Level Selection
n
Sets the signal level for analog output 5 (terminal V1).
No.
F4-05
Setting 0: 0 to 10 Vdc
Setting 1: -10 to 10 Vdc
F4-11: Analog Output 6 (Terminal V2) Monitor Selection
n
Selects the data to output from analog output 6 (terminal V2). Enter the final three digits of U -
monitor data is output from the option card. Some monitors are only available in certain control modes.
No.
F4-11
F4-12: Analog Output 6 (Terminal V2) Gain
n
Parameter F4-12 determines the gain. This parameter is set as a percentage of the output signal from analog output 6
(terminal V2) where 100% equals 10 V output. The terminal output voltage is limited to 10 V.
No.
F4-12
F4-13: Analog Output 6 (Terminal V2) Bias
n
Parameter F4-13 determines the bias. This parameter is set as a percentage of the output signal from analog output 6
(terminal V2) where 100% equals 10 V output. The terminal output voltage is limited to 10 V.
No.
F4-13
F4-14: Analog Output 6 (Terminal V2) Cell Selection
n
Parameter F4-14 determines the number of the power cell to be output from analog output 6 (terminal V2). This
parameter is effective when 9
Selection).
No.
F4-14
YASKAWA ELECTRIC TOEP C710687 03B FSDrive-MV1000 Parameter Guide
Name
Analog Output 5 (Terminal V1) Bias
Name
Analog Output 5 (Terminal V1) Cell Selection
Name
Analog Output 5 (Terminal V1) Signal Level Selection
Name
Analog Output 6 (Terminal V2) Monitor Selection
Name
Analog Output 6 (Terminal V2) Gain
Name
Analog Output 6 (terminal V2) Bias
(power cell) has been set for F4-11 (Analog Output 6 (Terminal V2) Monitor
Name
Analog Output 6 (Terminal V2) Cell Selection
2.6 F: Option Settings
Setting Range
-999.9 to 999.9% 0.0%
Setting Range
1 to 15 1
Setting Range
0 or 1 1
to determine which
Setting Range
000 to 999 103
Setting Range
-999.9 to 999.9 100.0
Setting Range
-999.9 to 999.9 0.0
Setting Range
1 to 15 1
Default
Default
Default
Default
Default
Default
Default
167