YASKAWA FSDrive-MV1000 Parameter Manual page 156

2.5 E: Motor Parameters
2.5 E: Motor Parameters
E parameters cover V/f pattern and motor data settings.
u E1: V/f Pattern for Motor 1
E1-04 to E1-13
n
No.
E1-04
E1-05
E1-06
E1-07
E1-08
E1-09
E1-10
E1-11
E1-12
E1-13
<1> Default setting depends on the control mode set in parameter A1-02. The value shown here is for V/f Control.
<2> The drive changes these settings when Auto-Tuning is performed (Rotational Auto-Tuning, Stationary Auto-Tuning).
<3> Parameter ignored when E1-11 and E1-12 are set to 0.0.
<4> When Auto-Tuning is performed, E1-13 and E1-05 will be set to the same value.
<5> When vector control is used, set the no-load voltage value.
Figure 2.42
Note: 1. The following condition must be true when setting up the V/f pattern: E1-09 ≤ E1-07 < E1-06 ≤ E1-11 ≤ E1-04
2. To make the V/f pattern a straight line below E1-06, set E1-09 = E1-07. In this case the E1-08 setting is disregarded.
3. When the parameters are initialized using parameter A1-03, the settings for E1-04 through E1-13 are returned to their default values.
4. Parameters E1-11, E1-12, and E1-13 should only be used to fine-tune the V/f pattern in the constant output range. These parameters
rarely need to be changed.
156
Name
Maximum Output Frequency
Maximum Voltage
Base Frequency
Middle Output Frequency
Middle Output Frequency Voltage
Minimum Output Frequency
Minimum Output Frequency Voltage
Middle Output Frequency 2
Middle Output Frequency Voltage 2
Base Voltage
Output Voltage (V)
Setting Range
40.0 to 120.0 Hz
0 to 13000 V
0.0 to120.0 Hz
0.0 to 120.0 Hz
0 to 13000 V
0.0 to 120.0 Hz
0 to 13000 V
0.0 to 120.0 Hz
0 to 13000 V
0 to 13000 V
Frequency (Hz)
Figure 2.42 V/f Pattern
YASKAWA ELECTRIC TOEP C710687 03B FSDrive-MV1000 Parameter Guide
Default
<1>
<1> <5>
<1>
<1>
<1>
<1>
<1>
0.0 Hz
<3>
0 V
<2> <3>
0 V
<2> <4>