Tools And Parts Required For Mx960 Router Connections - Juniper MX960 Hardware Manual

Table 115: Field-Replaceable Units
Hot-Removable and Hot-Insertable
FRUs
Air filter
Craft interface
Backup Switch Control Board (SCB) (if
redundant)
Master Switch Control Board (SCB) (if
nonstop active routing is configured)
Backup Routing Engine (if redundant)
Master Routing Engine (if nonstop active
routing is configured)
Dense Port Concentrators (DPCs)
Flexible PIC Concentrators (FPCs)
Modular Port Concentrators (MPCs)
Modular Interface Cards (MICs)
PICs
AC and DC power supplies (if redundant)
Fan tray
RELATED DOCUMENTATION
Taking an MX960 Host Subsystem Offline
Tools and Parts Required to Replace MX960 Hardware Components
Replacing the MX960 Craft Interface | 433
Replacing an MX960 Fan Tray | 456
Replacing the MX960 Air Filter | 453

Tools and Parts Required for MX960 Router Connections

To connect the router to management devices and line cards, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (–) screwdriver
2.5-mm Phillips (+) screwdriver
Hot-Pluggable FRUs
Master Switch Control Board (SCB) (if
nonstop active routing is not configured)
Master Routing Engine (if nonstop active
routing is not configured)
Switch Control Board (SCB)
(nonredundant)
Routing Engine (nonredundant)
Solid-state drives (SSDs) of Routing
Engines
378