Juniper MX960 Hardware Manual page 620

You hold an FPC vertically when installing it into the chassis or an equipment rack. To hold an FPC vertically
(see Figure 228 on page
1. Orient the FPC so that the faceplate faces you.
2. Place one hand around the FPC faceplate about a quarter of the way down from the top edge. To avoid
deforming the electromagnetic interference (EMI) shielding strip, do not press hard on it.
3. Place your other hand at the bottom edge of the FPC. If the FPC has heat sinks about midway between
the faceplate and connector edge, place your other hand against the heat sinks.
Figure 228: Holding an FPC Vertically
RELATED DOCUMENTATION
MX960 Flexible PIC Concentrator Description | 74
MX960 FPC Terminology
Storing an MX960 FPC | 611
610):
610