Reinstalling The Craft Interface - Juniper MX960 Hardware Manual

3. Tighten the captive screws on each side of the fan tray faceplate to secure it in the chassis.
Figure 100: Installing an Upper Fan Tray

Reinstalling the Craft Interface

To reinstall the craft interface, follow this procedure (see
NOTE: Figure 101 on page 315
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Grasp the craft interface with one hand and hold the bottom edge of the craft interface with the other
hand to support its weight.
3. Align the red line along the bottom of the internal strap with the bottom of the connector and snap
gently into place.
Figure 101 on page
does not show the extended cable manager installed.
315):
314