Dressing The Cables - Juniper MX960 Hardware Manual

Midplane
FPM Board
Display
PIM
PEM 0
in
PEM 1
in
Routing Engine 0 REV 02
Routing Engine 1 REV 04
CB 0
CB 1
FPC 2
CPU
PIC 0
...
Fan Tray 0
Fan Tray 1
Fan Extender
Under the Item field, verify that you see all hardware components installed in the chassis, including
the following:
FPM Board
Fan Tray 0
Fan Extender (Description field is Extended Cable Manager)
NOTE: The extended cable manager is shown in command output only in Junos OS Release
8.5 or later.

Dressing the Cables

To dress the cables within the extended cable manager, follow this procedure:
1. With a flatblade or Phillips screwdriver, loosen the two captive screws at the bottom of the cable
routing bay cover (see
and keep the cover in place.
2. Holding the captive screws, lift the cover straight up and out to remove it from the supporting posts.
Set the cover aside.
REV 02 710-013698
REV 01 710-014974
Rev 02 740-013110
Rev 01 740-013682
Rev 01 740-013682
740-013063
740-013063
REV 02.6 710-013385
REV 03 710-013385
REV 03 710-013699
REV 04 710-013713
BUILTIN
REV 01 740-014971
REV 01 740-014971
REV 01 710-018051
Figure 102 on page 319). The slots in the cover will rest on their supporting posts
CC6220 MX960 Midplane
JS4208 MX960 Front Panel
QCS10375009 Power Inlet Module
QCS10374009 PS 1.7kW; 200-240VAC
QCS10374029 PS 1.7kW; 200-240VAC
1000639065 RE-S-2000
1000664335 RE-S-2000
JM7908 MX960 SCB
JS9412 MX960 SCB
JS4284 MX960 40GE DPC
JS9401 MX960 DPC PMB
BUILTIN 10x 1GE
FT0655 MX960 Fan Tray
FT0653 MX960 Fan Tray
JZ8674 Extended Cable Manager
317