Installing The Mx960 Router Using A Mechanical Lift - Juniper MX960 Hardware Manual

7/16-in. (11 mm) nut driver
ESD grounding wrist strap
RELATED DOCUMENTATION
MX960 Site Preparation Checklist | 181
Removing Components from the MX960 Router Chassis Before Installing It with a Lift | 265

Installing the MX960 Router Using a Mechanical Lift | 276

Reinstalling Components in the MX960 Chassis After Installing It with a Lift | 320
Installing the MX960 Router Using a Mechanical Lift
Because of the router's size and weight—up to 350 lb (158.8 kg) depending on the configuration—you
must use mechanical lift to install the router.
CAUTION:
verify that the rack is strong enough to support the router's weight and is adequately
supported at the installation site.
To install the router using a lift (see
1. Ensure that the rack is in its permanent location and is secured to the building. Ensure that the installation
site allows adequate clearance for both airflow and maintenance.
2. Load the router onto the lift, making sure it rests securely on the lift platform.
3. Using the lift, position the router in front of the rack or cabinet, centering it in front of the mounting
shelf.
4. Lift the chassis approximately 0.75 in. above the surface of the mounting shelf and position it as close
as possible to the shelf.
5. Carefully slide the router onto the mounting shelf so that the bottom of the chassis and the mounting
shelf overlap by approximately two inches.
Before front mounting the router in a rack, have a qualified technician
Figure 68 on page 277):
276