Juniper MX960 Hardware Manual page 354

Figure 115: MX960 AC Power Input Mode Switch
1
0
CAUTION:
damage to the power supply.
5. Using both hands, slide the power supply straight into the chassis until the power supply is fully seated
in the chassis slot. The power supply faceplate will protrude beyond the chassis.
The small tab on the metal housing that is controlled by the release lever must be inside of the
corresponding slot at the bottom of the power supply (see
pull the power supply down in the chassis slot, prior to removing the power supply.
6. While firmly pushing the handle on the power supply faceplate with one hand, use your other hand to
pull the spring-loaded locking pin in the release lever away from the chassis and turn the release lever
clockwise until it stops.
7. Let go of the locking pin in the release lever. Ensure that the pin is seated inside the corresponding
hole in the chassis.
8. Locate a power cord with the type of plug appropriate for your geographical location (see
Cord Specifications for the MX960 Router" on page
9. Plug the power cord into the corresponding appliance inlet located in the chassis directly above the
power supply. This is the recommend receptacle when using the power supply in one-feed mode. If
using the power supply in two-feed mode, plug the second power cord into the receptacle on the power
supply.
Do not use a pencil, because fragments can break off and cause
221).
Figure 115 on page 339). This tab is used to
339
"AC Power