Scbe-Mx Leds - Juniper MX960 Hardware Manual

SCBE-MX LEDs

The FABRIC ACTIVE, FABRIC ONLY, and OK/FAIL LEDs indicate the status of the SCBE-MX. The BITS,
GPS, and UTI LEDs (next to the EXT CLK port) indicate the status of the respective clocking interface.
Table 75 on page 167 describes the behavior of the SCBE-MX LEDs.
Table 75: SCBE-MX LEDs
Label Color
FABRIC Green
ACTIVE
FABRIC Green
ONLY
–
OK/FAIL Green
Red
–
Red
–
NOTE: The LEDs BITS, GPS, and UTI are not currently supported.
BITS Green
Red
–
State Description
On Fabric is in active mode.
steadily
On SCBE-MX operates in fabric-only mode.
steadily
Off SCBE-MX operates in fabric/control board mode.
On SCBE-MX is online.
steadily
On SCBE-MX has failed.
steadily
Off SCBE-MX is offline.
On GPS clocking interface has failed.
steadily
Off GPS clocking interface is offline.
On Building-integrated timing supply (BITS) clocking
steadily interface is active.
On BITS clocking interface has failed.
steadily
Off BITS clocking interface is offline.
167