Figure 188: Removing a Routing Engine from an MX960 Router
Installing the Routing Engine RE-S-X6-64G
To install the Routing Engine RE-S-X6-64G:
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
2. Ensure that the ejector handles are not in the locked position. If necessary, flip the ejector handles
outward.
3. Place one hand underneath the Routing Engine to support it and carefully align the sides of the Routing
Engine with the guides inside the opening on the Switch Control Board SCBE2.
NOTE:
The Routing Engine RE-S-X6-64G is supported only on the SCBE2. RE-S-X6-64G
is not compatible with the SCB or the SCBE.
478