Scbe3-Mx Unsupported Functions And Capabilities From Legacy Scbs - Juniper MX960 Hardware Manual

Table 72: SCBE3 Interoperabilitiy with MPCs and Routing Engines (continued)
SCBE3-MX Operating
Mode
Supported Routing
Engines
NOTE: Enhanced IP is the default network service on the SCBE3-MX.
NOTE: Hyper-mode is the default forwarding mode on the SCBE3-MX. If your deployment does
not need hyper-mode, disable hyper-mode using the set forwarding-options no-hyper-mode cli
command before installing the Routing Engine into the SCBE3-MX.

SCBE3-MX Unsupported Functions and Capabilities from Legacy SCBs

The SCBE3-MX does not support the external UTI/DTI interface (front panel LED and daughter card
interface).
The SCBE3-MX does not interoperate with any previous generation SCBs (SCB, SCBE, and SCBE2).
Smooth upgrade is not supported.
The SCBE3-MX does not support the MPC1/2 NEO line card or legacy I-chip based line cards.
The SCBE3-MX does not support BITS.
The SCBE3-MX does not support DPCs.
The SCBE3-MX does not support mixed mode (DPC+MPC).
The SCBE3-MX does not support the JAM release.
The SCBE3-MX does not support MACsec.
RELATED DOCUMENTATION
Upgrading an MX240, MX480, or MX960 Router to Use the SCBE3-MX | 583
MX240/480/960
RE-S-1300(EOLed)
RE-S-2000 (EOLed)
RE-S-1800 (all variants)
RE-S-X6 (all variants)
Supported
no
no
yes
yes
156