Removing The Scbs Before Installing An Mx960 Router With A Lift - Juniper MX960 Hardware Manual

Figure 64: Removing a Lower Fan Tray

Removing the SCBs Before Installing an MX960 Router with a Lift

To remove the SCBs (see
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
3. Rotate the ejector handles simultaneously counterclockwise to unseat the SCB.
4. Grasp the ejector handles, and slide the SCB about halfway out of the chassis.
5. Place one hand underneath the SCB to support it, and slide it completely out of the chassis. Place it on
the antistatic mat.
Figure 65 on page 272):
271