Installing An Mx960 As Msc - Juniper MX960 Hardware Manual

Installing an MX960 AS MXC | 423
Removing an MX960 AS MLC | 441

Installing an MX960 AS MSC

To install an AS MSC (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Align the notches in the connector at the rear of the AS MSC with the notches in the AS MSC slot (slot
0—the top slot in the AS MLC ), and then slide the AS MSC in until it lodges firmly in the AS MLC.
CAUTION:
components on the bottom of the AS MSC.
3. Use one of the following methods to bring the AS MSC online:
Press the AS MSC offline/online button until the LED light turns green.
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
The normal functioning status LED confirms that the AS MSC is online. You can also verify correct AS
MSC functioning by issuing the show chassis fpc pic-status command..
Figure 154 on page 423):
Slide the AS MSC straight into the slot to avoid damaging the
CLI Explorer.
422