Installing An Mx960 Dual-Wide Mic - Juniper MX960 Hardware Manual

SEE ALSO
MX960 Modular Interface Card Description | 98
Maintaining MX960 MICs | 612
Troubleshooting the MX960 MICs | 662
Removing an MX960 MPC | 510
Removing an MX960 MIC | 499
Preventing Electrostatic Discharge Damage to an MX960 Router

Installing an MX960 Dual-Wide MIC

To install a dual-wide MIC (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Remove the septum, if necessary (see
a. Place the MPC on a flat surface (if necessary, remove the MPC from the router as described in
"Removing an MX960 MPC" on page
b. Remove the four screws labeled S on the bottom of the MPC.
c. Remove the two screws labeled S on the top of the MPC.
d. Slide the septum towards you and out of the MPC.
e. Store the septum and screws for later use.
f. Install the MPC as described in
Figure 145 on page 402):
Figure 144 on page
510).
"Installing an MX960 MPC" on page
400):
403.
506