Prepare The Mx960 Router For Scbe2-Mx Upgrade; Power Off The Mx960 Router - Juniper MX960 Hardware Manual

Prepare the MX960 Router for SCBE2-MX Upgrade

1. Verify that the system runs Junos OS Release 13.3 or later by issuing the show version command on
the master router.
user@host> show version
Model: mx960
Junos Base OS Software Suite [13.3-yyyymmdd];
...
NOTE: The SCBE2-MX is supported only on:
Junos OS Release 13.3 or later
Network Services Mode: Enhanced-IP
The latest software ensures a healthy system—that is, a system that comprises Routing Engines, control
boards, and FPCs—before the upgrade.
For information about how to verify and upgrade the Junos OS, see the Junos OS Installation and Upgrade
Guide.

Power Off the MX960 Router

NOTE: After turning off the power supply, wait at least 60 seconds before turning it back on.
1. On the external management device connected to the Routing Engine, issue the request system halt
both-routing-engines operational mode command. The command shuts down the Routing Engines
cleanly, so that their state information is preserved. (If the router contains only one Routing Engine,
issue the request system halt command.)
user@host> request system halt both-routing-engines
2. Wait until a message appears on the console confirming that the operating system has halted.
579