Mx960 Host Subsystem Leds On The Craft Interface; Mx960 Power Supply Leds On The Craft Interface; Mx960 Dpc And Mpc Leds On The Craft Interface - Juniper MX960 Hardware Manual

MX960 Host Subsystem LEDs on the Craft Interface

Each host subsystem has three LEDs, located in the middle of the craft interface, that indicate its status.
The LEDs labeled RE0 show the status of the Routing Engine in slot 0 and the SCB in slot 0. The LEDs
labeled RE1 show the status of the Routing Engine and SCB in slot 1.
functions of the host subsystem LEDs.
Table 7: Host Subsystem LEDs on the Craft Interface
Label Color
MASTER Green
ONLINE Green
OFFLINE Red
–

MX960 Power Supply LEDs on the Craft Interface

Each power supply has two LEDs on the craft interface that indicate its status. The LEDs, labeled 0 through
3, are located on the upper left of the craft interface next to the PEM label.
the functions of the power supply LEDs on the craft interface.
Table 8: Power Supply LEDs on the Craft Interface
Label Color
PEM Green
Red

MX960 DPC and MPC LEDs on the Craft Interface

Each DPC or MPC has LEDs on the craft interface that indicate its status. The LEDs, labeled 0 through 5,
2/6, and 7 through 11, are located along the bottom of the craft interface. Slot 2/6 is for an additional
DPC, FPC, MPC, or SCB.
State Description
On Host is functioning as the master.
steadily
On Host is online and is functioning normally.
steadily
On Host is installed but the Routing Engine is offline.
steadily
Off Host is not installed.
State Description
On Power supply is functioning normally.
steadily
On Power supply has failed or power input has failed.
steadily
Table 9 on page 21 describes the functions of the LEDs.
Table 7 on page 20 describes the
Table 8 on page 20
20
describes