Figure 70: Installing the Interface Module Cage Cover
Installing the Interface Module Cage Cover Front-Mount Brackets
To install the brackets for the interface module cage cover on routers that are front-mounted, use the
following procedure:
1. Locate the tab on the rear surface of the mounting bracket.
2. Place the rear surface of the bracket against the mounting flange. Vertical alignment is correct when
the tab rests on top of the flange.
3. Locate the highest available mounting hole on the bracket and insert the first screw through the bracket
and threaded rack flange.
4. Locate the lowest available mounting hole on the bracket and insert the second screw through the
bracket and threaded rack flange.
5. Use a screwdriver to hand tighten the screw . Do not overtighten the screws; overtightening may cause
damage to the plastic bracket.
6. Repeat the above steps with the second bracket.
Installing the Interface Module Cage Cover
To install the interface module cage cover, use the following procedure (see
1. Look through the front of the cover and align the four hooks on either side of the acoustic cover with
the rail slots on the outside of the card cage.
2. Slide the cover into the rail slots.
Figure 70 on page
281).
281