WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
CAUTION:
are inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Remove the cable from the cable manager and detach it from the destination port.
SEE ALSO
Preventing Electrostatic Discharge Damage to an MX960 Router
Installing a Cable on an MX960 DPC, MPC, MIC, or PIC | 408
Replacing an MX960 PIC | 517
Replacing an SFP or XFP Transceiver on an MX960 DPC, MPC, MIC, or PIC | 526
Installing a Cable on an MX960 DPC, MPC, MIC, or PIC
To install a cable:
1. Have ready a length of the type of cable used by the component. For cable specifications, see the
Series Interface Module
2. If the cable connector port is covered by a rubber safety cap, remove the cap.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
CAUTION:
are inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
Do not look directly into a fiber-optic transceiver or into the ends
Do not leave a fiber-optic transceiver uncovered except when you
Reference.
Do not look directly into a fiber-optic transceiver or into the ends
Do not leave a fiber-optic transceiver uncovered except when you
524
MX