Installing A Cfp Transceiver - Juniper MX960 Hardware Manual

CAUTION:
inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
5. Arrange the cable in the cable management system to prevent it from dislodging or developing stress
points. Secure the cable so that it is not supporting its own weight as it hangs to the floor.
CAUTION:
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
6. Unscrew the screws from the CFP transceiver faceplate to unseat the CFP transceiver from the line
card. Pull the CFP transceiver out of the line card and place it on the antistatic mat or in the electrostatic
bag.

Installing a CFP Transceiver

To install a replacement CFP transceiver:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the ESD point on the chassis.
2. Verify that a rubber safety cap covers the CFP transceiver, installing one if necessary.
3. Orient the CFP over the port in the line card so that the connector end will enter the slot first and the
CFP connector faces the appropriate direction.
4. Slide the CFP into the slot. If there is resistance, remove the CFP and flip it so that the connector faces
the other direction.
5. Remove the rubber safety cap from the transceiver and the end of the cable, and insert the cable into
the transceiver.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
Do not leave a fiber-optic transceiver uncovered except when
Avoid bending fiber-optic cable beyond its minimum bend radius.
Do not look directly into a fiber-optic transceiver or into the ends
534