Installing Ink Cassettes For The First Time - MUTOH ValueJet VJ-1204 User Manual

Eco-solvent ultra printer
Hide thumbs Also See for ValueJet VJ-1204:
Table of Contents

Advertisement

3.6 INSTALLING INK CASSETTES FOR THE FIRST TIME

Caution
When handling ink cassettes, be careful not to get ink into your eyes or on your skin. However,
if this happens, flush immediately with water. Otherwise, your eyes may become inflamed
slightly. If you feel discomfort, consult a doctor immediately.
Do not disassemble ink cassettes. Otherwise, ink may get into your eyes or on your skin.
Do not shake ink cassettes. Doing so may cause ink leakage.
Notes
When filling ink in the machine, use Mutoh original Eco-Solvent Ultra inks only.
This printer has been fine tuned for use of genuine ink cassettes. In case of non original ink cassettes
are used. Printing might become blurred and the end of ink in the cassette might no longer be correctly
detected.
The problems caused by doing so will not be covered by the warranty and repair expenses will have to
be paid by the customer.
Do not shake the ink cassettes strongly to avoid ink leaking out of the cassette.
Do not disassemble the ink cassette. A disassembled ink cassette cannot be used.
Make sure to use an original cleaning fluid (part No.: RJ80U-22-CLN).
Before installing the ink cassette, shake it gently. Doing so will preserve printing quality.
When storing the ink cassettes in a cold room, be sure to take them out of stock at least 3 hours before
using them.
Insert or remove the ink cassette not more than 10 times.
If the ink cassette is inserted or removed 10 times or more, it can not be used even if there is some
remaining ink inside.
Each ink cassette has a dedicating smart chip recognising ink types, colour and ink level inside of the
cassette. Taking out a cassette from its cassette slot during printing might result in damaging the smart
chip, causing the cassette to become obsolete.
To install the ink cassettes, follow the steps below.
Step 1 :
Switch ON the printer.
The printer starts initialization.
The operation panel displays "[KCMY] Discharged".
After the initial operation is complete, "Insert CleaningCart." is displayed on the operation panel.
32
AP-75740 – Rev 1.1 – 23/01/2007
User's Guide ValueJet 1204
Chapter 3: Installing the Unit

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents