Download Print this page

Otto Bock SensorHand Series Instructions For Use Manual page 23

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 19
Program 4:
Select the VarioControl mode for the SensorHand Speed in the MyoSoft or PAULA program.
Adjust each electrode so that the amputee can maintain the respective muscle signal for ap-
proximately two seconds at a point above the value HIGH (Fig. 7, item 1).
Note to Fig. 7 and 8: With programs 3 and 4 you can only see one curve!
8 Control modes
To define the desired program insert the appropriate coding plug (Fig. 2).
13E184=1 (white)
13E184=2 (red)
If the black coding plug (13E184=8) has been inserted into the electronic control unit of the
SensorHand Speed, the 757T13 MyoSelect can be used for setting all function types. For set-
ting the speed of the SensorHand Speed using 757T13 MyoSelect, any of the coding plugs can
be inserted. To do this read the 647G131 Instructions for Use manual.
Before changing the coding plug remove inner-hand safety ring. Partially remove the inner hand.
Change the coding plug (Fig. 2).
Return safety ring and inner hand.
To reset the system so that it will recognize the new coding plug, remove the battery and reinsert
it. Ten program variants are available.
9 Program survey
Program 1
DMC plus Sensor
White coding plug
Two electrodes
Program 2
AutoControl –
LowInput
Red coding plug
Two electrodes
AutoControl –
LowInput
Red coding plug
One electrode & one
optional Ottobock
Switch
AutoControl –
LowInput
Red coding plug
Any Ottobock switch
SensorHand Speed
13E184=3 (green)
13E184=4 (blue)
OPEN
Myo-signal to the
electrode
Proportional speed
OPEN
Myo-signal to the
electrode
Proportional speed
Myo-signal to the
electrode
Proportional speed
Hand opens as long
as opening side of the
switch is activated
Constant speed
13E184=5 (yellow)
13E184=6 (purple)
CLOSE
Myo-signal to the
electrode
Proportional speed
CLOSE
Myo-signal to the
electrode digitally (short
signal at any level)
Constant speed
Signal from the switch
Constant speed
Signal from closing side
of switch: Hand closes
Constant speed
13E184=8 (black)
Indication
Preferred program for
amputees with two strong
muscle signals
Indication
For amputees with two
weak muscle signals
For amputees with only 1
muscle and weak muscle
signal
For patients with too
weak or no muscle signal
Ottobock | 23

Advertisement

loading

This manual is also suitable for:

Sensorhand 8e39 8Sensorhand 8e38 8Sensorhand 8e41 8