Service And Replacement Of Airbags - MG ZS Series Manual

Service and Replacement of Airbags

Service Information
DO NOT install or modify the airbag. Any
changes to the vehicle structure or airbag
system wiring harness are strictly prohibited.
Changes to vehicle structure is prohibited.
This may affect the normal operation of the
SRS.
DO NOT allow these areas to be flooded with
liquid and DO NOT use petrol, detergent,
furniture cream or polishes.
If water contaminates or enters the SRS it
may cause damage and affect deployment.
In this case contact an MG Authorised
Repairer immediately.
To prevent damage to the airbag SRS, the following
areas should be cleaned sparingly with a damp cloth and
upholstery cleaner ONLY:
SEATS & RESTRAINTS
• Steering wheel centre pad.
• Area of dashboard containing the passenger airbag.
• Area of roof lining and front pillar finishers which
enclose the side head impact protection modules.
If the airbag warning lamp fails to illuminate, stays on, or
if there is damage to the front or side of the vehicle, or
the airbag covers show signs of damage, contact an MG
Authorised Repairer immediately.
IMPORTANT
• The removal or replacement of an airbag module
should be carried out by an MG Authorised Repairer.
• After 10 years from the initial date of registration
(or installation date of a replacement airbag), some
components will need to be replaced by an MG
Authorised Repairer. The appropriate page of the
Service Portfolio must be signed and stamped once
the work has been completed.
3
111