Table of Contents
Advertisement
Configuration (WBM)
4.8 Start page
The "Overview" tab
The "Overview" tab shows a picture of the RTU. When you are connected to the operating
RTU, the LED symbols shown in the WBM reflect the original status of the LEDs on the RTU.
● Status LED
If an error occurs (the "STATUS" LED is lit or flashes red) a message text is output in this
line.
● Show diagnostics buffer
You can jump directly to the page of the diagnostics buffer via the link and check the
diagnostics messages.
Navigation in the WBM
By clicking on an entry in the navigation area on the left open the WBM page you want for
further information or on which you want to configure or program.
The WBM opens the first tab of the entry.
4.8.2
Status
The tab provides an overview of important status data of the RTU. Some of the display
parameters are commented on below.
Note on navigation:
By clicking on the titles (bold and underlined) of the parameter groups you jump directly to
the relevant WBM page.
General
Information on the device and the configuration data of the station
● Program execution
Runtime status of the program (controller)
● Station name
The station name configured in "System" > "General".
● System runtime (dd:hh:mm:ss)
Runtime of the RTU since commissioning or since the last restart
Power supply
Information about the battery module being used or about the external power supply
● Day of the last battery change
Time of the last changeover of the battery currently being used (when one battery module
is empty and there was a changeover to the other one).
Ethernet interface
Information on the LAN interface
88
Operating Instructions, 09/2017, C79000-G8976-C382-04
RTU3030C
Advertisement
Table of Contents
