Table of Contents
Advertisement
RCM
The RTU meets the requirements of the AS/NZS 2064 standards (Class A).
National wireless approvals
To operate the device in certain countries approvals for wireless operation must exist, the
agreed marking must be present on the type plate and special instructions for the particular
country must be adhered to. Some of the national approvals and instructions are shown
below.
Australia / New Zealand
Australian Communications and Media Authority, for compliance levels 1, 2 and 3 in
Australia and levels of conformity 1, 2 and 3 in New Zealand. As required by notices under:
● section 182 of the Australian
● section 407 of the Australian
● section 134 of the New Zealand
Canada
CONTAINS IC: 5131A-HE910
IC statement:
This device complies with part 15 of the FCC Rules and Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Mexico
La operación de este equipo está sujeta a las siguientes dos condiciones:
(1) es posible que este equipo o dispositivo no cause interferencia perjudicial y
(2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda
causar su operación no deseada.
RTU3030C
Operating Instructions, 09/2017, C79000-G8976-C382-04
Radiocommunications Act 1992
Telecommunications Act 1997
Radiocommunications Act 1989.
Approvals
;
; and
271
Advertisement
Table of Contents
