Table of Contents
Advertisement
Logging
See section Configuration of the tags , general parameters (Page 150).
The option whether and when process data of the signal is saved on the SD card, also
applies here for saving the mean value, if mean value formation was enabled in the
parameter group. "Additional value".
Additional value
● Mean value generation
Select a degree of mean value generation over several update cycles:
– None
– Weak
– Medium
– Strong
Diagnostics messages
● Wire break
If wire break is detected at life-zero inputs, if the option is enabled a message is entered
in the diagnostics buffer
With other measured variables, the option has no effect.
● Outside the measuring range
If the option is enabled, a message is entered in the diagnostics buffer when
under/overvoltage or under overcurrent is detected.
With temperature measurements, the option has no effect.
For over/undershoot ranges or over/underflow, refer to the section "Measuring ranges".
Regardless of configured diagnostics messages, the LED of an input (Aix) is lit red with wire
break, over/undervoltage or under/overcurrent.
RTU3030C
Operating Instructions, 09/2017, C79000-G8976-C382-04
No mean value generation
Mean value generation over 2 cycles
Mean value generation over 4 cycles
Mean value generation over 8 cycles
Configuration (WBM)
4.18 Tags
159
Advertisement
Table of Contents
