Siemens SIMATIC RTU3030C Operating Instructions Manual page 134

Telecontrol - rtu
Hide thumbs Also See for SIMATIC RTU3030C:
Table of Contents

Advertisement

Configuration (WBM)
4.16 User / Recipient
Note
Loss of changed standard user data
Note changed or newly assigned user names and passwords.
If you change user data of the standard user, lose the changed user data and have not
created a second user, you no longer have access to the WBM of the RTU. In this case, you
can only access the WBM after resetting the RTU to the factory settings. Resetting to factory
settings involves the loss of the configuration data, refer to the section Operating status
(Page 103).
Note
Entering the wrong user name or password
After entering an incorrect user name or incorrect password three times a lockout time of 5
seconds begins after which you can log in again.
User
A total of 20 users can be created.
You will find a description of the rights of the users in the section "Rights of the users".
Table
The table shows all users and their configured data.
● Add
Creates a new user.
When you create a new user, you need to assign the name, the user name and the
password. . You can leave the other data boxes empty and complete them later.
● Delete
Deletes the user selected in the table above.
When you click the "Delete" button, two buttons are displayed as a prompt for
confirmation:
– Delete
– Cancel
All users except at least one can be deleted.
You configure the individual users below the table.
Change user
The following data can be configured optionally. Some data is necessary for the
communication functions of the RTU.
134
Deletes the selected user once and for all.
Cancels the deletion and the normal picture of the WBM page is shown again.
Operating Instructions, 09/2017, C79000-G8976-C382-04
RTU3030C

Advertisement

Table of Contents
loading

Table of Contents