Denso BHT-1260BWB-CE User Manual page 96

BHT-1200 Series
[4] Power Management
"Power Management" is used to set the automatic power-off timer and
standby timer.
To set up, double tap the "Power Management" icon in the System
Properties.
Automatic Power off Time:
Battery Power (sec):
Selects the automatic power-off time from 0 to 600 seconds, when the
BHT is not set in the CU.
The power does not automatically turn OFF when "0" is set.
External Power (sec): (Default: 0)
Selects the automatic power-off time from 0 to 1800 seconds, when the
BHT is set in the CU.
The power does not automatically turn OFF when "0" is set, or when
the BHT is communicating via a LAN.
There will be a time delay of a few seconds when automatically turning off the power after the specified
time has elapsed.
When the "Enable automatic power off with wireless communication" check box is selected, the
power turns OFF automatically even during wireless communication.
- when automatic power-off time is set to 0
- when automatic power-off time is set to a non-zero value : refer to the following chart.
Checked
Unchecked
 
Point
Switch to Standby Mode:
Timer (x 100 ms):
Sets the waiting time to be switched to the standby mode in 100ms units.
(10: 100ms x 10 = 1 second)
Value
0
1 to 9
10 to 600
84
(Default: 180)
During wireless
communication
The power does NOT
turn OFF automatically
The power does not turn OFF for 10 seconds once the power turns ON.
Description
Disable the standby mode
1 second
1 to 60 seconds
: The power does not automatically turn OFF.
When wireless
communication is
disconnected
The power automatically turns OFF
The power turns OFF
automatically.
When the BHT
communicates via the CU
The power does NOT
Turn OFF automatically.