Denso BHT-1260BWB-CE User Manual page 186

BHT-1200 Series
BHT-1200Q Series
Tap the "1: SCANNER" button in the HardTest menu to perform the code
scanning test. The screen shown on the right is displayed.
Scan an actual code with the BHT, and confirm that the scanned data
matches with the data shown on the screen.
When a code is scanned, the LED indicator illuminates in blue, and the
beeper sounds once.
The scanned code type, number of digits and scanned data are displayed
in the screen.
The code type and number of digits are displayed with bold italic fonts in
the order as shown below.
Code Mark TYPE1 ( Code Mark TYPE2 ) number of digits
When the scanned data exceeds 500 bytes, tap the down arrow on the
right side of the screen to view the next data, and tap the up arrow to view
the previous data.
Read Parameter: Opens the scanner reading parameter menu. (refer to
"4.8 Scanner Reading Parameter")
QR code and iQR code can be divided up to 16 codes from a single code. The multiple
- Point -
codes divided are called split codes. The split codes are reconstructed as a single code
when all split codes are read.
The beeper sounds differently when the split codes are read.
The beeper sounds twice when the first split code is read, then the BHT goes into the split
code reading mode. For the second and subsequent readings, the beeper sounds once
every time the split code is read.
The read data is displayed all at once as a complete code when all split codes are read.
During the split code reading, if a non-split QR or iQR code is read, the trigger key is
released, or a next split code is not read within 5 seconds;
The split codes can be read in random order.
The same split code will not be read twice.
174
- a non-split code just read is displayed on the screen, then
- the split code reading mode is cancelled, and
- the split codes already read are discarded.

Code Mark (Type1)
Code Mark (Type2)
number of digits
scanned data