Denso BHT-1260BWB-CE User Manual page 38

BHT-1200 Series
Details of the procedures below can be changed in the BHT Backup menu and Startup Config menu.
Refer to Chapter 4, 4.4.3 System Properties -[11] Data Backup and [12] Startup Configuration.
Procedures
Follow the procedures [1] through [6] after full reset, [5] through [6] after reset.
[1] Backup
(BHTBackup.exe)
Automatic restore
(BHTRestore.exe)
[2] Registry backup
Registry automatic
restore
(Regload.exe)
[3] File automatic copy
(Regload.exe)
(Reset internally)
[4] Execute program
automatically
And /or
Reset(Warm boot)
[5] Execute program
automatically
(Windows Startup)
[6] Execute program
automatically
[Compatibility with
the past functions]
− Point −
The bat files (*.bat, *.cmd) stored in the following folder are executed as hidden files
in procedure [4], [5] and [6] if the bat file name starts with '_'(underscore).
26
Outlines
Back up data (files) and registry using backup tool.
Restore backup details automatically when rebooting after full reset.
For further details, refer to Chapter 4, 4.4.3 System Properties - [11] Data Backup and [12]
Startup Configuration.
"Registry backup" or "Registry automatic restore" can be performed independently.
Refer to Chapter 2, 2.5.2 Turning the Power OFF after Registry Back-up.
[Note]
When [1] "automatic restore" function is activated, the contents backed up using this
"registry backup" function is not automatically restored.
Copy files (data) stored in specific folders of the on-board FLASH memory in the order
listed below.
Folders to copy from
\Flash\Startup\Windows
\Flash\Copyfile
[Note]
"\Flash\Copyfile" folder is strongly recommended, and
"\Flash\Startup\Windows" should be only used with older series of BHT.
<Example> Folders to copy from
\Flash\Copyfile\Windows
\Flash\Copyfile\Program Files
Execute the programs automatically including applications stored in the "\Flash\Setup"
folder. Execute setup application and install the CAB files, too.
[Specific execution with bat file]
Execution order can be defined with the "*.bat" file.
[Example autorun.bat]
wceload /noui /delete 0 \Flash\SetUp\dnwa.cab
call apl1setup.bat
call apl1setup.bat
regedit /H /I \Flash\Setup\Regfile\setup.reg
[Note] For further details about registry setup, refer to Chapter 4, 4.4.3 System Properties
-[13] Registry editor.
Execute programs automatically including applications stored in "\Windows\Startup".
Execute programs automatically including applicators stored in "\FLASH\Startup"
[Note] This function is used with older BHT series.
function [4] : "\Flash\Setup"
function [5] : "\Windows\Startup"
function [6] : "\Flash\Startup"
Folders to copy to Notes
\Windows Does NOT copy files in
sub folders.
\(root folder) Copy files in sub folders
<Example> Folders to copy to
Windows
Program Files
' CAB Install
' Application1 setup
' Application2 setup
' registry setup