Denso BHT-1260BWB-CE User Manual page 93

LIGHT (LIGHT mode)
The light mode can be set.
0: AUTO (default)
1: Always ON
2: Always OFF
SCAN MODE
Select the scan mode either "NORMAL" or "POINT".
NORMAL: Normal read mode (default)
POINT: Point Scan mode
The point scan mode is used to read a code by aiming at the center cross section of the leaser light
marker. The laser light marker is used to indicate the barcode reading position.
A code cannot be read in the point scan mode, if there is no code within the cross section, or if
unable to detect the marker due to external light, and so on.
The point scan mode can be used only when the laser light marker is enabled and the normal read
mode is selected.
MARKER
The "MARKER" is used to set whether the laser light marker illuminates or not, when a trigger key is
pressed.
0: Normal
The laser light marker illuminates during barcode reading. (default)
1: Always ON
The laser light marker illuminates during barcode reading, and stays illuminated for the first 30
seconds until the barcode is read.
2: Always OFF
The laser light marker never illuminates.
 Note  Setting to "Always ON" increases the power consumption, and may shorten the operation
time as compared to the other two settings.
Changing the settings is not recommended unless necessary.
Barcode Handy Terminal/2D code Handy Terminal
Hand Held Terminal
Barcode Handy Terminal
81