Denso BHT-1260BWB-CE User Manual page 130

BHT-1200 Series
[24] ActiveSync/WMDC Automatic Connection
The ActiveSync/WMDC is set to automatically connect via the USB as
default.
The ActiveSync/WMDC Automatic Connection can be changed in the
advanced system menu.
To enable or disable, follow the steps below.
1. Open the System Properties menu.
2. Hold down the SHIFT key and press the "1" key.
The "Communication Settings" screen shown on the right is
displayed.
3. Check or Uncheck the box to enable or disable,
then tap the "OK" button.
 Note 
Automatic connection is enabled as default.
[25] Power key
The LED and Beeper can be used as notification devices to notify that the
BHT is turned on by the power key.
To change the notification device, follow the steps below.
1. Open the System Properties menu.
2. Hold down the SHIFT key and press the "2" key.
The "Power Key" screen shown on the right is displayed.
LED:
Beeper:
3. Select the notification device.
Both the LED and Beeper can be selected at the same time.
[26] Battery charging mode
Hold down the SHIFT key and press the 8 key while the System menu is
open. The Battery menu shown on the right is displayed.
The Eco mode reduces power consumption compared to the Normal
mode when charging a battery while the BHT is turned off (in suspend
mode).
Normal
Eco
Select the Eco mode when the BHT using in the state of California.
118
Blue LED (Default)
Beeper
Normal mode
Eco mode :
Complies with California appliance efficiency
regulations for battery chargers.