Wwan Manager; Wwan Manager Menu - Denso BHT-1260BWB-CE User Manual

BHT-1200 Series

4.7 WWAN Manager

"WWAN Manager" is a wireless WAN setup tool to connect the BHT via a wireless wide area network.

4.7.1 WWAN Manager menu

To open the WWAN Manager, double tap the "Wireless WAN" icon in the
System Properties.
The WWAN Manager provides the following menus.
General:
Data Connection :
Security :
Bands :
Info :
Ping:
- Note -
Data connection started by the WWAN manager will be disconnected when the
WWAN manager is closed.
Do not close the WWAN manager if data connection is needed to be ON.
The power status of the WWAN module will not be changed by closing the WWAN
manager.
- Note -
When replacing the battery, remove the battery cover after turning off either the
WWAN module or the BHT.
- Note -
The WWAN module may take some time to turn back ON if turned ON immediately
after turning OFF.
- Note -
When turning on and off the BHT while the WWAN module is ON, wait at least 30
seconds after turning off the BHT before turning it back on again.
- Point -
If the WWAN module is ON at reset (warm boot), the WWAN module will be turned
ON after reset (warm boot)
156
Turns ON or OFF the WWAN module,
connect or disconnect data connection,
displays connection status
Sets up data connection
Authenticates the PIN,
enables or disables the SIM PIN, changes the PIN
Displays available frequency bands
Displays the IMSI and IMEI information
Checks the WWAN communication status